Xerox DOCUPRINT N4525 Service Quick Reference Manual page 409

Replacement
1.
Place shaft on the rear side of the Roller (PL 20.7.5) through the bearing on the
rear side.
2.
Insert the shaft on the front side of the Transport Roller into the bearing on the
front side of the Finisher, and secure it with the E-Ring (PL 20.7.12).
3.
Install the One-Way Gear on the rear of the Inlet Roller shaft with the shoulder
toward the Frame and secure it with an E-Ring.
4. Mount the Drive Assembly Bracket with three screws.
5.
Mount the Wiring Harness in Clamps.
6.
Mount Input Path Ssensor Bracket.
7. Connect Path Sensor Harness (P/J 1).
8.
Mount the Top Center Cover Assembly (RRP 6-23).
9.
Mount the Top Cover-Left (RRP 6-22).
10.
Mount the Rear Cover (RRP 6-21).
11.
Mount the Front Cover-Open, Front Cover and Kit Stud Cover (RRP 6-17).
12.
Mount the Front and Rear Top Covers (RRP 6-16).
13.
Mount the Jogging Cover (RRP 6-14).
Volume 6 / Finisher - RRPs 6-741