Fig 3-7 Duplex Unit Assembly; Fig 3-10 Duplex Unit - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RRP 3-1 Duplex Unit Assembly (PL 14.1)
Duplex Unit

Fig 3-7 Duplex Unit Assembly

Removal
1.
Disconnect the Duplex Unit interface cable from the rear of the printer.
2.
Tilt the Duplex Unit back so it is open half way.
3.
Unhook the Support Cable from the printer frame.
4.
Support the Duplex Unit with your left hand.
5.
Close the Duplex Unit such that you can release the metal arm that runs from
the Unit to the metal stud on the front of the Multi-sheet Bypass Feeder
Support (see the lower inset in the illustration).
6.
Open the Duplex Unit all the way and lift it up to remove it from the printer.
Replacement
1. Hold the Duplex Unit so the front of the Unit is facing down and the metal
hinges facing the printer.
2.
Slip both the front and rear hinges onto the metal studs on the front and rear
Multi-sheet Bypass Feeder Supports.
3.
Support the Duplex Unit with your left hand.
4.
Close the Duplexer Unit such that you can hook the metal arm that runs from
the Duplexer Unit to the metal stud on the front Multi-sheet Bypass Feeder
Support.
5.
Hook the Support Cable to the printer frame and close the Duplex Unit.
6. Reconnect the Duplex Unit interface cable at the rear of the printer.
3-526 DocuPrint N4525 Network Laser Printer - Service Guide
S4525-252