Xerox DOCUPRINT N4525 Service Quick Reference Manual page 109

Replacement
1.
Insert the Retard Assembly into the High Capacity Feeder as shown in the
figure.
2.
Insert the bearing end of the Shaft into the bearing cutout at the front of the
High Capacity Feeder frame.
3.
Slide the Shaft far enough to the front so you can insert the rear of the Shaft
into the cutout in at the rear of the High Capacity Feeder frame.
4. Slide the Shaft to the rear, and seat the Bearing at the front of the shaft into the
bearing cutout at the front of the High Capacity Feeder frame (Figure 3).
5.
Slide the Take Away Bearing onto the shaft (Figure 3).
6. Reinstall the Retard Gear.
7.
Reinstall the Fixed Gear and use an E-ring to secure it to the shaft.
8.
Reinstall the Take Away Gear and use an E-ring to secure it to the shaft.
9.
Reinstall the Drive Transmission Gear and use an E-ring to secure it to the
shaft.
10.
Reinstall the Bracket to the High Capacity Feeder frame, and use two screws
to secure it.
11.
Reinstall the Tray 3 Feed Clutch (RRP 10.13).
12.
Reconnect J211 and J213 to the Bracket, and route the wire harness through
the harness clips.
13.
Lift the Retard Shaft up and out of the way while you slide the Feed In Chute
under the Retard Assembly and against the High Capacity Feeder frame.
14.
Slide the Chute to the rear of the High Capacity Feeder so the rear of the
Chute hooks on to the frame, and the screw hole at the front of the Chute
aligns with the screw hole in the High Capacity Feeder frame.
15.
Use one screw to secure the Feed In Chute to the High Capacity Feeder
frame.
16.
Reinstall the plastic Upper Take Away Chute onto the three bearings on the
Take Away Roller (Figure 1).
17.
Reinstall the Inner Chute onto the High Capacity Feeder frame.
18.
Use two screws to secure the Inner Chute.
19.
Reinstall the Spring to the left side of the Inner Chute.
20.
Reinstall the High Capacity Feeder Left Door C (RRP 2-3).
21.
Reinstall the Rear Cover (RRP 2-2).
22.
Reinstall Tray 3.
Volume 2 / High Capacity Feeder - RRPs 2-441