Xerox DOCUPRINT N4525 Service Quick Reference Manual page 468

Replacement
Insert the Shaft ELEV,L (PL 20.14.13) a little into the hole on the front side of
1.
the Finisher, then at the inside of the Finisher, insert the Gear (PL20.14.15)
and Encoder Drive Pulley (PL 20.14.28) up to the hole on the rear side of the
Finisher.
Insert the Bearing (PL 20.14.26) into the front side of the Shaft ELEV,L.
2.
3.
Insert the Pin (PL 20.14.11) into the hole on the front side of Shaft ELEV,L, and
then insert the Pulley (PL 20.14.12) into the Shaft ELEV,L so that the slit of the
Pulley comes in position.
4.
Secure the front side of the Shaft ELEV,L with an E-ring.
5. For the rear side, perform the above steps (STEPS 2-4) in the same manner.
6.
At the inside of the Finisher, insert the Pin into the hole on the front side, and
then slide the Gear up to its mounting position so that the slit of the Gear
comes in position.
7.
Secure the front side of the Gear with an E-ring.
8.
At the inside of the Finisher, insert the Pin into the hole on the rear side, and
then slide the Encoder Drive Pulley up to its mounting position so that the slit of
the Encoder Drive Pulley comes in position.
9.
Secure the front side of the Encoder Drive Pulley with an E-ring.
10.
Mount the Holder Assembly (RRP 6-75).
11.
Mount the
Encoder Assembly (RRP 6-82)
12.
Mount the
Drive Assembly-ELEV and Motor Assembly-MD11
13.
Mount the
Right Cover
14.
Mount the Front Cover-Open Front Cover and Kit Stud Cover (RRP 6-17).
15.
Mount the Rear Cover (RRP 6-21).
16.
Mount the Front and Rear Top Cover (RRP 6-16).
17.
Mount the Jogging Cover (RRP 6-14).
6-800 DocuPrint N4525 Network Laser Printer - Service Guide
(RRP 6-81).
.
(RRP 6-80).