Fig 2-26 Tray 3 (Cont'd) - Xerox DOCUPRINT N4525 Service Quick Reference Manual

Sliding the Feed In Chute to the front unhooks the Chute from the
Note
High Capacity Feeder frame.
10.
Push the Chute back and remove it from the frame.
11.
Disconnect P/J211 from Tray 3 Feed Clutch.
12. Disconnect J211 and J213 from the Bracket (PL 12.4.8) (Figure 2), and free
the wire harness from the harness clips.
13.
Remove the two screws securing the Bracket to the High Capacity Feeder
frame, and remove the Bracket.
14.
Remove Tray 3 Feed Clutch (RRP 2-13).
15. Remove the E-ring securing the Drive Transmission Gear to the shaft and
remove the Gear.
16.
Remove the E-ring securing the Take Away Gear to the shaft and remove the
Gear.
17.
Remove the E-ring securing the Fixed Gear to the shaft and remove the Gear.
18.
Slide the Retard Gear off of the shaft.
19.
Slide the Take Away Bearing off of the shaft.
20.
Slide the Retard Assembly to the front of the High Capacity Feeder, then
swing the rear of the Assembly out of the High Capacity Feeder (Figure 3).

Fig 2-26 Tray 3 (cont'd)

2-440 DocuPrint N4525 Network Printer - Service Guide
S4525-215