Xerox DOCUPRINT N4525 Service Quick Reference Manual page 199

RRP 3-6 Duplex Wait Clutch (PL 14.2)
Fig 3-12 Duplex Wait Clutch
Removal
1.
Remove the Duplex Rear Cover (RRP 3-3).
2.
Disconnect P/J224 (wait Clutch) from the Duplex Board.
3.
Remove the E-ring from the end of the Wait Clutch shaft.
4.
Push up on the shaft latch as you slide the Clutch off of the shaft.
Replacement
1.
Position the Wait Clutch so the notch in the Clutch lines up with the tab on the
Duplex Unit frame.
2. Slide the Clutch onto the shaft.
The shaft latch snaps the Clutch into place on the shaft.
3.
Use an E-ring to secure the Clutch to the shaft.
4.
Reconnect P/J224 to the Duplex Board.
5.
Reinstall the Duplex Rear Cover (RRP 3-3).
Volume 3 / Duplex Unit - FRU RRPs 3-531