RRP 6-74 Elevator Bearing Kit (PL 20.14)
Fig 6-61 Elevator Bearing Kit
Removal
1.
Remove the Jogging Cover (RRP 6-14).
2.
Remove the Front and Rear Top Cover (RRP 6-16).
3.
Remove the Rear Cover (RRP 6-21).
4.
Remove the Front Cover-Open Front Cover and Kit Stud Cover (RRP 6-17).
5.
Remove the Stacker Bin.
6.
On the Front side of the Finisher, loosen the two screws that secures the
Bracket Tray (PL 20.14.30).
7.
On the Rear side of the Finisher, Loosen the two screws that secures the
Bracket Tray (PL 20.14.30), and Remove the Bracket Tray.
8.
Remove the Holder Assembly (PL 20.14.98).
9.
Remove the screw that secures the Bearing Assembly to the Bracket Front (PL
20.14.3), and remove the Bearing Assembly. (Figure 2)
10.
Repeat the above steps until you have removed all the Bearing Assemblies.
Replacement
1.
Reverse the Removal procedure above.
Figure 1
Figure 2
Volume 6 / Finisher - RRPs
S4525-499
6-793