Xerox DOCUPRINT N4525 Service Quick Reference Manual page 475

Removal
16.
Remove two screws that secure to the Finisher from the Cover Lower Left, and
remove the Cover Lower Left.
17.
Remove two screws that secure the LVPS Cover Upper (PL 20.15.2) to the
LVPS Cover Lower.
18.
Remove two screws that secure to the LVPS Cover Lower and remove.
19.
Remove the screw that secures the grounding wire of the Power Supply to the
LVPS Cover Lower (Figure 2).
20.
Unplug the connector (P/J CN2) of the Harness Motor (PL 20.15.13) from the
Power Supply (Figure 2).
21. Unplug the connector (P/J CN1) of the Harness Motor (PL 20.16.13) from the
Power Supply (Figure 2).
22.
Remove six screws that secure to the LVPS Cover Lower from the Power
Supply, and remove the Power Supply (Figure 2).
Replacement
1.
Align the Power Supply (PL 20.15.3) with the mounting position in the LVPS
Cover Lower (PL 20.15.2), and secure it with six screws (Figure 2).
2.
Secure the grounding wire of the Power Supply to the LVPS Cover Lower with a
screw. (Figure 2)
3.
Plug the connector (P/J CN1) of the Harness Motor (PL 20.16.13) to the Power
Supply. (Figure 2)
4. Plug the connector (P/J CN2) of the Harness Motor (PL 20.16.13) to the Power
Supply. (Figure 2)
5.
Align the LVPS Cover Lower with mounting position in the Finisher, and with
the tabs on the Rear of cover aligned in the slots on the frame, push LVPS
Lower Cover with Power Supply toward Rear of Finisher and secure it with two
screws.
6.
Mount LVPS Upper cover with two screws.
7.
Align the Cover Lower Left (PL 20.4.18) with the mounting position in the
Finisher, and secure it with two screws.
Volume 6 / Finisher - RRPs 6-807