Xerox DOCUPRINT N4525 Service Quick Reference Manual page 439

Removal
1.
Remove the Jogging Cover (RRP 6-14).
2. Remove the Front and Rear Top Cover (RRP 6-16).
3.
Remove the Left Cover.
4.
Remove the Exit Sensor (RRP 6-54).
5.
Remove the Safety Switch (RRP 6-57).
6.
Remove two screws that secure to the Shaft (PL 20.11.12) from the Support
(PL 20.11.36), and remove the Support.
7.
Avoiding the Actuator (PL 20.11.8), release the Roller Shaft (PL 20.11.39) from
two bearings of Compiler Guide (PL 20.11.11) and remove the Roller Shaft
together with two Compiler Roller (PL 20.11.38).
Replacement
1.
Avoiding the Actuator (PL 20.11.8) with your Finisherger, mount the Roller
Shaft (PL 20.11.39) together with two Compiler Roller (PL 20.11.38) on two
bearings of Compiler Guide (PL 20.11.11).
2.
Insert two bosses of Support (PL 20.11.36) into the holes in the Compile
Guide, and align the Shaft (PL 20.11.12) to its mounting position so that it
pushes the hook of the Spring (PL 20.11.51), then secure with two screws.
3.
Mount the Safety Switch (RRP 6-57).
4.
Mount the Exit
5.
Mount the Left Cover.
6. Mount the Front and Rear Top Cover (RRP 6-16).
7.
Mount the Jogging Cover (RRP 6-14).
(RRP 6-54).
Sensor
Volume 6 / Finisher - RRPs 6-771