Duplex Unit Error Code Table; Table 3-3 Duplex Unit Error Codes - Xerox DOCUPRINT N4525 Service Quick Reference Manual

Duplex Unit Error Code Table

This table lists all of the Duplex Unit related Error Codes that are generated by the Print
Engine Controller Board.
Depending on the level of firmware on your Print Engine
Note
Controller Board some codes listed in this table may be invalid,
some codes generated by the Print Engine Controller may not
appear in this table, and Error and Message Code text presented
in this table may differ slightly from the Error and Message Code
text that is actually generated by your Print Engine Controller.

Table 3-3 Duplex Unit Error Codes

Diplayed Error
Message
Paper Jam
Clear Duplx Unit
Close Duplx Unit
Paper Jam
Clear Duplx Unit
Paper Jam
Clear Duplx Unit
Paper Jam
Clear Duplx Unit
Paper Jam
Clear Duplx Unit
Paper Jam
Clear Duplx Unit
3-508 DocuPrint N4525 Network Laser Printer - Service Guide
Error Fault Description
Code
E4-2 There is a paper jam at the Duplex Exit Sensor.
Logic control on the Print Engine Controller Board
sensed that the Duplex Exit Sensor did not
actuate within the specified time after the Face Up
Exit Sensor was actuated.
E7-3 The Duplex Cover is Open.
The Duplex Unit is closed, but logic control on the
Print Engine Controller Board sensed that the
Duplex Interlock Switch is open.
E8-1 There is a jam at the Duplex Exit Sensor.
Inverted page to be output to the Face Up Bin did
not leave the Duplex Exit Sensor within the
specified time.
E8-2 There is a paper jam between the Face Up Exit
Sensor and the Duplex Wait Sensor.
Logic control on the Print Engine Controller Board
sensed that the Duplex Wait Sensor did not
actuate within the specified time after the Face Up
Exit Sensor was actuated.
E8-6 There is a problem with the Duplex Exit
Sensor.
Remaining paper detected in the Duplex Unit.
C6-1 There is a paper jam between the duplex Wait
Sensor and the registration Sensor.
Logic control on the Print Engine Controller Board
sensed that the Registration Sensor did not
actuate within the specified time after the Duplex
Wait Clutch was actuated.
C8-6 There is a paper jam at the Duplex Exit sensor.
Logic control on the Print Engine Controller Board
sensed that there is paper remaining in the Duplex
Unit.
RAP Unit
No. Page
3-1 3-509
3-2 3-511
3-3 3-512
3-4 3-514
3-5 3-516
3-6 3-518
3-7 3-520