RRP 5-2 Face-Up Bin with the Duplex Unit
Fig 5-5 Face-Up Bin attached to the Optional Duplex Unit
Removal
1.
Remove the Face-Up Bin from the Bin Cover.
2.
Remove the link on the inside front of the Bin Cover by lifting up, then removing
from the Duplex Unit and Bin Cover.
3.
Remove the two screws securing the Bin Cover to the Duplex Unit.
4.
Remove the Cover Tray.
Installation
Step 1 below is performed only one time. The Cut-out Plate is
Note
removed when installing the FUB on the Duplex Unit the first time
only. The Cut-out Plate is not reinstallable.
1.
Remove the cut-out plate from the front of the Duplex Unit.
2.
Reverse the above procedures.
Volume 5 / Face-Up Bin
S4525-604
5-619