Xerox DOCUPRINT N4525 Service Quick Reference Manual page 202

RRP 3-9 Duplex Exit Gate Solenoid (PL 14.3)
Fig 3-15 Duplex Exit Gate Solenoid
Removal
1.
Remove the Duplex Cover (RRP 3-2)
2.
Remove the Duplex Rear Cover (RRP 3-3).
3.
Disconnect P/J222 from the Duplex Board.
4.
Remove the wire harnesses from the wire clip that is mounted on the Solenoid
Bracket.
5.
Remove the two screws securing the Duplex Exit Gate Solenoid to the Bracket,
and remove the solenoid.
6. If removal of the Solenoid is required, remove the two screws securing the
Duplex Exit Gate Solenoid Bracket to the Duplex frame
7.
Remove the Bracket.
Replacement
1.
Reinstall the Duplex Gate Solenoid Bracket to the Duplex Frame
2.
Reinstall the Duplex Exit Gate Solenoid onto the bracket.
3.
Rotate the Solenoid plunger so the fork in the Link slips through the slot in the
plunger.
4.
Use two short black screws to secure the Solenoid to the Bracket.
5. Lift and release the Solenoid plunger to make sure it opens the Link correctly.
6.
Reconnect P/J222 to the Duplex Board.
7.
Reroute the wire harness through the wire clip located on the Solenoid Bracket.
8.
Reinstall the Duplex Rear Cover (RRP 3-3).
9.
Reinstall the Duplex Cover (RRP 3-2).
3-534 DocuPrint N4525 Network Laser Printer - Service Guide
S4525-260