Xerox DOCUPRINT N4525 Service Quick Reference Manual page 353

Table 6-19 Error Code F4-61 (cont'd.)
Step Actions and Questions
5 PATH PAPER INSPECTION
Inspect the Exit Rollers in the Compiler.
Are all of the Exit Rollers in the Compiler clean
and free of obvious wear and damage?
DRIVE TRAIN TEST
6
1. Enter Diagnostics Mode.
2. From the Main Menu, select Comp Output Test /
Finisher Unit / Exit Motor CW.
3. Press [4] to start, [0] to stop.
4. From the Main Menu, select Comp Output Test /
Finisher Unit / Exit Motor CCW.
5. Press [4] to start, [0] to stop.
Does the Compiler Exit Motor run smoothly
and rotate clockwise and counter clockwise?
7 DRIVE TRAIN INSPECTION
Inspect the drive train, including belts, pulleys, and gears.
Does the drive train appear to be in good
condition, with no damaged or slipping belts
and no chipped or broken pulleys or gears?
8
The following Finisher components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one at
a time, until you isolate and solve the problem.
Compiler Exit Path Sensor (RRP 6-54)


Finisher Main Board (RRP 6-84)


Print Engine Controller Board (RRP 1-72)


Exit Motor (RRP 6-59)


Wiring and connectors linking the components


Volume 6 / Finisher - Error Codes & Messages
Yes No
Go to step 6 Replace the
suspect
Rollers &
retest. If the
problem still
exists, go to
step 6.
Go to step 7 Replace the
Compiler Exit
Motor (RRP
6-59) &
retest. If still
NO, to to step
7.
Go to step 8 Replace the
suspect belts,
pulleys, gears
& retest. If
still NO, go to
step 8.
6-685