Xerox DOCUPRINT N4525 Service Quick Reference Manual page 473

Removal
1.
Remove the Jogging Cover (RRP 6-14).
2. Remove the Stacker Bin.
3.
Remove the Front and Rear Top Cover (RRP 6-16).
4.
Remove the Rear Cover (RRP 6-21).
5.
Remove the Front Cover-Open Front Cover and Kit Stud Cover (RRP 6-17).
6.
Remove the Kit Bearing (RRP 6-74).
7. Remove the Right Cover (RRP 6-81).
8.
Remove the Punch Dust
9.
Remove the
Inner Cover (RRP 6-45).
10. Remove the
Right Cover (RRP 6-81).
11.
Remove the Elevator
12.
Unplug the connector (CN39) from the Encoder Assembly.
13.
Remove two screws securing the Encoder Assembly, and remove it.
Replacement
1.
Loosen the screw that secures the bracket jig of the Encoder Assembly, align
the rectangular hole in large gear with the bracket position, insert the bracket
into the rectangular hole, and secure the bracket with the screw.
In the following steps, two simultaneous operations may need two
Note
persons.
2.
With the Top Tray Bracket (PL 20.14.3) aligned with the markings on both
sides of Finisher (bottom of the upper stay of the Finisher), align the Encoder
Assembly with its mounting position in the Finisher, then secure with two
screws.
3.
Plug the connector (CN39) to the Encoder Assembly.
4.
Loosen the screw that secures the bracket jig of the Encoder Assembly, pull the
bracket out of the rectangular hole in large gear, and secure the bracket with
the screw.
5.
Mount the Elevator
6.
Mount the
Right Cover (RRP 6-81).
7.
Mount the Kit Bearing (RRP 6-74).
8.
Mount the
Inner Cover (RRP 6-45).
9.
Mount the Punch Dust
10.
Mount the Right Cover (
11.
Mount the Front Cover-Open Front Cover and Kit Stud Cover (RRP 6-17).
12. Mount the Rear Cover (RRP 6-21).
13.
Mount the Front and Rear Top Cover (RRP 6-16).
14.
Mount the Stacker Bin.
15. Mount the Jogging Cover (RRP 6-14).
Bottle.
Drive and Motor (MD11) Assemblies (RRP 6-80).
Drive and Motor (MD11) Assemblies (RRP 6-80).
Bottle.
).
RRP 6-81
Volume 6 / Finisher - RRPs 6-805