Fig 6-65 Lower Elevator Shaft Assembly; Rrp 6-79 Lower Elevator Shaft Assembly (Pl 20.14) - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RRP 6-79 Lower Elevator Shaft Assembly (PL 20.14)

Fig 6-65 Lower Elevator Shaft Assembly

Removal
1.
Remove the Jogging Cover (RRP 6-14).
2.
Remove the Front and Rear Top Cover (RRP 6-16).
3.
Remove the Rear Cover (RRP 6-21).
4.
Remove the Front Cover-Open Front Cover and Kit Stud Cover (RRP 6-17).
5.
Remove the
Right Cover
6.
Remove the
Drive Assembly-ELEV and Motor Assembly-MD11
7.
Remove the
Encoder Assembly (RRP 6-82)
8.
Remove the Holder Assembly (RRP 6-75).
In the following steps, removing the Pulley (PL 20.14.12)
Note
allows the Pin (PL 20.14.11) to be unsecured and easily
removed from the Shaft ELEV,L (PL 20.14.13). Accordingly,
take care not to drop or lose it.
Remove the E-ring that secures the Gear (PL 20.14.15) to the Shaft ELEV,L,
9.
slide the Gear toward the front, and remove the Pin.
Remove the E-ring that secures the Encoder Drive Pulley (PL 20.14.28) to the
10.
Shaft ELEV,L, slide the Gear (PL 20.14.15) toward the rear, and remove the
Encoder Drive Pulley.
Remove the E-ring that secures the Bearing (PL 20.14.26) and Pulley on the
11.
front side to the Shaft ELEV,L, and pull off the Pulley, and then pull the Pin off
the hole on the front side of the Shaft ELEV,L.
12.
Remove the E-ring that secures the Bearing and Pulley on the rear side to the
Shaft ELEV,L, and pull off the Pulley, and then pull the Pin off the hole on the
rear side of the Shaft ELEV,L.
13. Remove the front and rear Bearing that secure the Shaft ELEV,L to the
Finisher, and pull off the Shaft ELEV,L.
(RRP 6-81).
Volume 6 / Finisher - RRPs
S4525-504
.
(RRP 6-80).
6-799