Table 6-35 Error Code H6-8 - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RAP 6-32
Error Code H6-8
There is an identification problem with the Finisher.
Logic Control on the Print Engine Controller Board sensed that the installed Finisher is
not compatible with the printer.

Table 6-35 Error Code H6-8

Step Actions and Questions
1 FINISHER INSPECTION
Inspect the Finisher to make sure it is the correct
manufacture and model for the printer.
Is the Finisher the correct manufacture and
model for this printer?
RESET
2
1. Switch off the printer and the Finisher.
2. Wait one minute, then switch on the printer and the
Finisher
Is the error code gone?
3 RESEAT
Disconnect then reconnect the Finisher from the printer.
Is the error code gone?
FINISHER MAIN BOARD REPLACEMENT
4
Replace the Finisher Main Board (RRP 6-84).
Is the error code gone when you power the
printer on?
5 The following Finisher components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one at
a time, until you isolate and solve the problem.
Finisher Main Board (RRP 6-84)


Print Engine Controller Board (RRP 1-72)


Broken or damaged components within the


Stapler area, Compiler area, or along the paper
path
Wiring and connectors linking the components.


6-710 DocuPrint N4525 Network Laser Printer - Service Guide
Install Correct
Finisher
Yes
Go to step 2
Problem
solved
Problem
solved
Problem
solved
No
Replace the
Finisher with
a correct one
Go to step 3
Go to step 4
Replace the
Print Engine
Controller
Board (RRP
1-72) &
retest. If still
NO, go to
step 4.