Installing Shield (No Conditioner) - MacDon R113 Operator's Manual

Installing Shield (No Conditioner)

Follow these steps to install the shielding on a self-propelled disc header configured without a conditioner:
1. Position shielding (A) until pins (B) engage the slots in
cutterbar support (C) and bolt holes (D) align with
panel (E).
2. Install four M16 hex head bolts (A), nuts, and flat
washers to secure shield (B) to the panel (C). Ensure
bolt heads face inboard.
214077
MAINTENANCE AND SERVICING
Figure 4.165: Header Left Side
Figure 4.166: Header Left Side
179
D
D
E
B
C
A
A
C
A
B
Revision A