5. Inspect right side roll conditioner U-joints (A) for signs of
wear or damage.
6. Inspect right side roll timing gearbox bearings (A) for
signs of wear or damage.
4.7.7 Changing the Conditioner
The R113 self-propelled disc header can be operated either with no conditioner, with a polyurethane roll
conditioner, or with a steel roll conditioner. If the header is not conditioner equipped, a shield must be installed.
Follow these instructions to change conditioners.
NOTE:
These instructions apply to all conditioners. Exceptions are identified where applicable.
Removing the Conditioner
This procedure is applicable when the header is not attached to the windrower. If necessary, detach the header
from the windrower before proceeding.
1. Open the driveshields. Refer to
2. Remove the conditioner drive belt. Refer to
214077
MAINTENANCE AND SERVICING
3.7.1 Opening Driveshields, page
Removing Conditioner Drive Belt, page
170
A
Figure 4.141: Right Side Roll Conditioner
U-Joints
A
Figure 4.142: Right Side Roll Timing Gearbox
Bearings
62.
158.
Revision A