MacDon R113 Operator's Manual page 186

3. Carefully align pin (B) at each end of conditioner (A)
with lug (C) on header. Lower the conditioner (A), so
that pins (B) engage lugs (C) on header
4. Align mounting holes and install four M16 x 40 hex head
bolts (A) with heads facing inboard (two per side).
Secure with M16 center lock flanged nuts and torque to
170 Nm (126 lbf∙ft).
5. Remove lifting chains from conditioner and move lifting
device clear of work area.
6. If necessary, install conditioner drive components.
Refer to Installing Conditioner Drive, page
7. Position forks (B) under frame as shown ensuring
packing foam (A) (or equivalent) is between forks and
frame. Raise forks to lift frame slightly. Ensure forks do
not contact frame.
8. To secure frame to forks, wrap chain (C) around end of
forks and attach to forklift.
9. Pick up frame and position it against header as shown.
214077
MAINTENANCE AND SERVICING
Figure 4.152: Installing Conditioner
176.
Figure 4.153: Left Side of Conditioner –
Right Side Similar
Figure 4.154: Installing Frame
174
A
C
B
A
C
A
B
A
C
Revision A