Conditioners; Conditioner Drive Belt; Inspecting Conditioner Drive Belt - MacDon R113 Operator's Manual

4.7 Conditioners

4.7.1 Conditioner Drive Belt

The conditioner drive belt is located inside the left driveshield and is tensioned with a spring tensioner. The tension
is factory-set and should not require adjustment.

Inspecting Conditioner Drive Belt

Check the belt tension and inspect for damage or wear every 100 hours or annually (preferably before the start of
the cutting season).
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Lower self-propelled disc header fully, turn off engine, and remove key.
2. Open the left side driveshield (A). Refer to
Opening Driveshields, page
3. Inspect drive belt (A) and replace if damaged or
cracked.
4. Check that jam nut (B) and adjuster nut (C) are tight.
214077
MAINTENANCE AND SERVICING
3.7.1
62.
157
Figure 4.114: Left Side Driveshield
B
C
A
Figure 4.115: Conditioner Drive
A
Revision A