Preseason Servicing; End-Of-Season Servicing - MacDon R113 Operator's Manual

4.3.3 Preseason Servicing

CAUTION
• Review the operator's manual to refresh your memory on safety and operating recommendations.
• Review all safety signs and other decals on the self-propelled disc header and note hazard areas.
• Ensure all shields and guards are properly installed and secured. Never alter or remove
safety equipment.
• Make certain you understand and have practiced safe use of all controls. Know the capacity and the
operating characteristics of the machine.
• Check the first aid kit and fire extinguisher. Know where they are and how to use them.
Perform the following procedures at the beginning of each operating season:
1. Lubricate machine completely. Refer to
2. Perform all annual maintenance. Refer to

4.3.4 End-of-Season Servicing

CAUTION
Never use gasoline, naphtha, or any volatile material for cleaning purposes. These materials may be toxic
and/or flammable.
CAUTION
Cover cutterbar to prevent injury from accidental contact.
Perform the following procedures at the end of each operating season:
1. Clean the self-propelled disc header thoroughly.
2. Store in a dry, protected place if possible. If stored outside, always cover self-propelled disc header with a
waterproof canvas or other protective material.
3. Raise self-propelled disc header and engage lift cylinder safety props.
4. Repaint all worn or chipped painted surfaces to prevent rust.
5. Loosen drive belt.
6. Lubricate the self-propelled disc header thoroughly leaving excess grease on fittings to keep moisture out of
bearings.
7. Apply grease to exposed threads, cylinder rods, and sliding surfaces of components.
8. Oil cutterbar components to prevent rust.
9. Check for worn components and repair as necessary.
10. Check for broken components and order replacements from your Dealer. Immediate repair of these items will
save time and effort at beginning of next season.
11. Replace or tighten any missing or loose hardware. Refer to
12. Remove divider rods (if equipped) to reduce space required for inside storage.
214077
MAINTENANCE AND SERVICING
4.4 Lubrication, page 105
4.3.1 Maintenance Schedule/Record, page
7.1 Torque Specifications, page
104
and 3.12 Cutterbar Lubrication, page
101.
73.
191.
Revision A