Installing Outboard Curtains - MacDon R113 Operator's Manual

3. Remove two nuts (A) from bolt studs.
4. Remove nut (B) from carriage head bolt, slide out the
bracket (C), and remove curtain (D).

3.13.7 Installing Outboard Curtains

The procedure for installing outboard curtains is the same for both sides.
1. Open cutterbar door (A). Refer to
Cutterbar Doors, page
2. Install curtain (A) into bracket (B).
3. Install two nuts (D) and tighten.
4. Slide bracket (B) into position, and install the square
neck carriage head bolt and flange nut (C).
5. Torque flange nut (C) to 39 Nm (29 lbf·ft).
214077
3.8.2 Opening
65.
OPERATION
Figure 3.127: Outboard Curtain
Figure 3.128: Cutterbar Doors
Figure 3.129: Outboard Curtain
82
C
A
A
B
D
D
B
A
C
Revision A