Removing Non-Driven Drums - MacDon R113 Operator's Manual

14. Close cutterbar doors. Refer to
Doors, page 68.

Removing Non-Driven Drums

DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage windrower lift cylinder safety props before going under machine for any reason.
CAUTION
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
1. Open cutterbar doors (A). Refer to
Cutterbar Doors, page
NOTE:
Arrows in the following illustrations point to the front of
the machine.
214077
MAINTENANCE AND SERVICING
3.8.4 Closing Cutterbar
3.8.2 Opening
65.
Figure 4.86: Cutterbar Doors in Closed Position
A
Figure 4.87: Cutterbar Doors
145
Revision A