MacDon R113 Operator's Manual page 66

5. Disconnect the following electrical harness and
hydraulic hoses from the windrower:
a. Disconnect the return hose from receptacle (A).
b. Disconnect the pressure hose from receptacle (B).
c. Disconnect the case drain hose from
receptacle (C).
d. Disconnect the electrical harness from
receptacle (D).
6. Remove hose support weldment (A) from the windrower
and place in storage position on the header. Slide
weldment support cylinder (B) into support on
center-link (C) and secure with hardware (D).
214077
OPERATION
Figure 3.73: Header Drive Hydraulics
Figure 3.74: Hose Support Weldment, Storage
Position
54
C
D
A
C
D
B
A
B
Revision A