3.13.3 Installing Cutterbar Door Curtains
The procedure for installing cutterbar door curtains is the same for both doors.
1. Insert the cutterbar door stud bolts (B) into the precut
holes on curtain (A).
2. Install seven large washers (C).
3. Install liner panel (D) against washers.
4. Install seven nuts (E) onto bolt studs and torque to
28 Nm (21 lbf·ft).
IMPORTANT:
To avoid damaging bolt studs, do not overtighten
the nuts.
5. Close cutterbar doors. Refer to
Doors, page
68.
3.13.4 Removing Cutterbar Inboard Curtain
1. Open cutterbar doors (A). Refer to
Cutterbar Doors, page
2. Remove two M10 carriage head bolts (A) and nuts
securing curtain assembly (B) to the self-propelled disc
header, and remove curtain assembly.
214077
3.8.4 Closing Cutterbar
3.8.2 Opening
65.
OPERATION
B
D
Figure 3.118: Curtain Installed onto Bolts
Figure 3.119: Cutterbar Doors
Figure 3.120: Inboard Curtain
79
A
B
A
A
C
E
Revision A