Break-In Inspections - MacDon R113 Operator's Manual

Action
Change roll timing gearbox lubricant.
▲
Refer to Checking and Changing Roll
Timing Gearbox Oil, page
Change header drive gearbox
▲
lubricant. Refer to
Adding Lubricant, page

4.3.2 Break-In Inspections

Table 4.1 Break-In Inspection Schedule
Inspection
Interval
1 Check for loose hardware and
Hour tighten to required torque
Check for loose hardware and
tighten to required torque
5
Hours
Check conditioner drive belt
tension
25 Check conditioner drive belt
Hours tension
Check conditioner drive belt
tension
Check and change cutterbar
lubricant
50
Hours
Check and change conditioner roll
timing gearbox lubricant
Check and change header drive
gearbox lubricant
Check conditioner drive belt
tension
Check and change cutterbar
lubricant
150
Hours
Check and change conditioner roll
timing gearbox lubricant
Check and change header drive
gearbox lubricant
214077
MAINTENANCE AND SERVICING
ü ü Check
161.
4.6.1 Checking and
156.
Item
S S Lubricate
7.1 Torque Specifications, page 191
7.1 Torque Specifications, page 191
Inspecting Conditioner Drive Belt, page 157
Inspecting Conditioner Drive Belt, page 157
Inspecting Conditioner Drive Belt, page 157
3.12 Cutterbar Lubrication, page 73
Use only specified amount. Do NOT overfill.
4.7.2 Roll Timing Gearbox (MD #221748), page 161
Checking and Changing Roll Timing Gearbox Oil, page 161
Inspecting Conditioner Drive Belt, page 157
3.12 Cutterbar Lubrication, page 73
Use only specified amount. Do NOT overfill.
4.7.2 Roll Timing Gearbox (MD #221748), page 161
Checking and Changing Roll Timing Gearbox Oil, page 161
103
▲ Change
Refer to
Revision A