Attaching R1 Series Sp Disc Header To M155E4 Windrower: Hydraulic Center-Link Without Self-Alignment - MacDon R113 Operator's Manual

15. Start the engine and activate the HEADER DOWN
switch (A) on the GSL to fully lower the header.
16. Stop engine and remove key from ignition.
3.5.3 Attaching R1 Series SP Disc Header to M155E4 Windrower: Hydraulic
Center-Link without Self-Alignment
1. Remove hairpin (B) from clevis pin (A) and remove
clevis pin from the header supports (C) on both sides of
the header.
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to the windrower, ensure the float engagement
pin is installed in storage position (B) and NOT in
engaged position (A).
CAUTION
Check to be sure all bystanders have cleared the area.
214077
OPERATION
A
Figure 3.34: Ground Speed Lever
Figure 3.35: Header Support
Figure 3.36: Header Float Linkage
37
C
B
A
B
A
Revision A