MacDon R113 Operator's Manual page 41

CAUTION
To prevent damage to the header lift linkages when
lowering header lift legs without a header or weight box
attached to the windrower, ensure the float springs
tension is fully released.
NOTE:
If not prompted by the Harvest Performance Tracker (HPT)
display to remove float, remove float manually. Refer to
windrower operator's manual for instructions.
4. Press HEADER DOWN switch (E) on the ground speed
lever (GSL) to fully retract header lift cylinders.
5. Hydraulic center-link with self-alignment: Press the
REEL UP switch (B) on the GSL to raise the center-link
until the hook is above the attachment pin on
the header.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
6. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue to drive
slowly forward until feet engage the supports and
header nudges forward.
7. Ensure that windrower feet (A) are properly engaged in
header supports (B).
214077
OPERATION
Figure 3.12: Header Float Spring
C
Figure 3.13: Ground Speed Lever
A - Reel Down
C - Header Tilt Down
E - Header Down
Figure 3.14: Header Support
29
B
F
D
E
B - Reel Up
D - Header Tilt Up
F - Header Up
A
B
A
Revision A