MacDon R113 Operator's Manual page 43

10. Press the HEADER UP switch (A) to raise header to
maximum height.
NOTE:
If one end of the header does NOT fully raise, rephase
the lift cylinders as follows:
a. Press and hold the HEADER UP switch (A) until
both cylinders stop moving.
b. Continue to hold the switch for 3–4 seconds.
Cylinders are now phased.
11. Stop the engine and remove the key.
12. Engage safety prop on lift cylinder as follows:
a. Pull lever (A) and rotate toward header to release,
and lower safety prop onto cylinder.
b. Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over the cylinder piston
rods. If safety prop does not engage properly, raise
header until prop fits over the rod.
13. Install clevis pin (A) through support and foot and
secure with hairpin (B). Repeat for opposite side.
IMPORTANT:
Ensure clevis pin (A) is fully inserted, and hairpin is
installed behind bracket.
214077
OPERATION
Figure 3.17: Ground Speed Lever
Figure 3.18: Cylinder Safety Prop
Figure 3.19: Header Support
31
A
A
B
A
Revision A