Cutterbar Lubrication; Checking And Adding Cutterbar Lubricant - MacDon R113 Operator's Manual

3.12 Cutterbar Lubrication

3.12.1 Checking and Adding Cutterbar Lubricant

DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
CAUTION
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
1. Park the self-propelled disc header on level ground.
2. Position self-propelled disc header so that the cutterbar is approximately level.
3. Shut down the self-propelled disc header, and remove key.
4. Open cutterbar doors (A). Refer to
Cutterbar Doors, page
5. Use a spirit (bubble) level to ensure the cutterbar is
level in both directions. Raise or lower self-propelled
disc header accordingly.
214077
3.8.2 Opening
65.
OPERATION
Figure 3.107: Cutterbar Doors
Figure 3.108: Spirit Level on Cutterbar
73
A
Revision A