Installing Cutterbar Inboard Curtain - MacDon R113 Operator's Manual

3. Remove four nuts (A) from weld studs on center shield,
remove two curtain brackets (B), and remove curtain.

3.13.5 Installing Cutterbar Inboard Curtain

1. Open cutterbar doors (A). Refer to
Cutterbar Doors, page
2. Install curtain onto weld studs on center shield, install
two curtain brackets (B), and secure with four nuts (A).
3. Torque to 28 Nm (21 lbf·ft).
IMPORTANT:
To avoid damaging bolt studs, do not overtighten
the nuts.
214077
3.8.2 Opening
65.
OPERATION
A
B
Figure 3.121: Inboard Curtain, Nuts, and
Brackets
Figure 3.122: Cutterbar Doors
Figure 3.123: Inboard Curtain and Brackets
80
A
A
B
B
B
Revision A