Servicing Amber Hazard/Signal Lights - MacDon R113 Operator's Manual

Servicing Amber Hazard/Signal Lights

Replacing Amber Hazard/Signal Bulb
1. Remove two Phillips screws (A) from fixture, and
remove the plastic lens.
2. Replace bulb, and reinstall plastic lens and screws.
Bulb—Trade #1157.
Replacing Amber Hazard/Signal Light Fixture
1. Remove four nuts (A) (only 3 shown) securing light to
bracket and remove light. Disconnect light from
electrical harness.
2. Connect new light to the electrical harness
3. Install four nuts (A) and tighten.
214077
MAINTENANCE AND SERVICING
Figure 4.128: Plastic Lens and Screws
Figure 4.129: Amber Hazard Light
164
A
A
A
Revision A