MacDon R113 Operator's Manual page 184

6. To protect the finish on the frame, wrap packing
foam (A) (or equivalent) around frame at approximate
shown locations.
7. Position forks (B) under the packing foam on the frame
as shown at right. Raise forks and lift frame slightly. The
forks should not directly contact the frame.
8. To secure frame to forks, wrap chain (C) around end of
forks and attach to forklift.
9. Remove nut (A), securing bolt (B) and washer (C), and
washer shims (D) from the center-link support attaching
header to frame (E). If necessary, adjust height of forks
lifting the frame. Retain hardware for reinstallation.
10. Remove nut (B).
11. Remove bolt (A) from frame (C). If necessary, adjust the
height of forks lifting the frame to provide more room
and better access to bolt (A). Repeat at opposite side
of frame. Retain hardware for reinstallation.
214077
MAINTENANCE AND SERVICING
Figure 4.146: Supporting Frame
Figure 4.147: Frame (Center-Link Support)
Figure 4.148: Frame (Left Side Shown)
172
C
A
B
D
D
B
C
B
A
C
A
C
A
Revision A