8.4.2 Installing Shield (No Conditioner)
Follow these steps to install the shielding on a mower configured without a conditioner:
1. Position shielding (A) until pins (B) engage the slots in
cutterbar support (C) and the bolt holes align with
panel (D).
2. Install four M16 hex head bolts (A), nuts, and flat
washers to secure shield (B) to the panel (C). Ensure
bolt heads face inboard.
214075
CHANGING THE CONDITIONER
Figure 8.30: Header Left Side
Figure 8.31: Header Left Side
81
Revision A