MacDon R113 Operator's Manual page 68

9. Engage safety prop on lift cylinder as follows:
a. Pull lever (A) and rotate toward header to release,
and lower safety prop onto cylinder.
b. Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over the cylinder piston
rods. If safety prop does not engage properly, raise
header until prop fits over the rod.
Windrowers with center-link self-alignment kit only:
10. Release the center-link latch (A) before returning to
the cab.
11. Disengage safety prop by turning lever (A) downwards
until lever locks into the vertical position.
12. Repeat for the opposite side.
CAUTION
Check to be sure all bystanders have cleared the area.
13. Start engine and remove header float when prompted by the Harvest Performance Tracker (HPT).
214077
OPERATION
Figure 3.77: Cylinder Safety Prop
Figure 3.78: Center-Link
Figure 3.79: Safety Props
56
A
A
A
Revision A