MacDon R113 Operator's Manual page 82

4. Position left deflector (A) on top of ledge along the aft
end of the cutterbar, and align existing fasteners and
cutterbar plug with slots in deflector (A).
5. Install three button hex head socket M10 bolts (B) with
lock nuts in the holes with the heads facing down.
6. Install bolt (C) shared with skid shoe on outboard end of
deflector.
7. Position right deflector (A) on top of ledge along the
outboard end of the cutterbar, and install button hex
head socket M10 bolts (B) with lock nuts in the holes
with the heads facing down.
8. Install bolt (C) shared with skid shoe on outboard end of
deflector.
9. Align deflectors at position (B) and tighten bolts (C) to
specified torque with a 16 mm socket and an 8 mm
hex key.
214077
OPERATION
C
Figure 3.104: Left Cutterbar Deflector Viewed
from Underside of Cutterbar
B
Figure 3.105: Right Cutterbar Deflector Viewed
from Underside of Cutterbar
70
A
B
B
A
B
B
B
C
Revision A