Connecting R1 Series Hydraulics And Electrical: M155E4 Windrowers - MacDon R113 Operator's Manual

7. Remove protective plugs (A) from return line fitting (B)
and pressure line fitting (C).
IMPORTANT:
Keep open lines and ports clean.
8. Connect hydraulic hoses and electrical harness to
receptacles on windrower as follows:
a. Connect pressure hose to receptacle (A).
b. Connect return hose to receptacle (B).
c. Connect case drain hose to receptacle (C).
d. Connect the electrical harness to receptacle (D).
NOTE:
The hydraulic hoses should have enough slack to pass
by the multicoupler (E) without coming into contact with
it. This will protect the hoses from rubbing against the
multicoupler and becoming damaged. You can increase
slack in the hoses by loosening and adjusting the hose
holder on the front windrower leg, and pulling the hoses
backward toward the windrower.
9. Close the windrower's left side platform. Refer to
windrower operator's manual for procedure.

Connecting R1 Series Hydraulics and Electrical: M155E4 Windrowers

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
214077
OPERATION
A
Figure 3.53: Protective Plugs
Figure 3.54: M1170 Hydraulic and Electrical
Connections
44
C
A
C
A
E
B
D
B
Revision A