Lubrication; Greasing Procedure - MacDon R113 Operator's Manual

4.4 Lubrication

WARNING
To avoid personal injury, before servicing header or opening drive covers, refer to
for Servicing, page 97.
Greasing points are marked on the machine by decals
showing a grease gun and the grease interval in hours
of operation.
Log hours of operation and use the maintenance schedule
provided to keep a record of scheduled maintenance. Refer
to 4.3.1 Maintenance Schedule/Record, page

4.4.1 Greasing Procedure

Only use clean high pressure extreme pressure grease. Refer to this manual's inside back cover for a list of
recommended fluids and lubricants.
CAUTION
To avoid bodily injury or death from unexpected startup of machine, always stop engine, and remove key
from ignition before leaving operator's seat for any reason.
1. Open driveshields at ends of self-propelled disc header to access greasing points. Refer to
Driveshields, page 62.
2. Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
3. Inject grease through fitting with grease gun until grease overflows fitting (except where noted).
4. Leave excess grease on fitting to keep out dirt.
5. Replace any loose or broken fittings immediately.
6. Remove and thoroughly clean any fitting that will not take grease and clean lubricant passageway. Replace
fitting if necessary.
214077
MAINTENANCE AND SERVICING
101.
Figure 4.6: Grease Interval Decal
105
4.1 Preparing Machine
3.7.1 Opening
Revision A