MacDon R113 Operator's Manual page 187

10. Slowly move forward until the lift arm (C) is lined up with
the mounting holes in the frame (A) and (B).
11. Install only bolt (A) through the frame (B) and
bushing (D) in the lift arm. Repeat for opposite side.
12. Check the gap (C) between the inner steel sleeve (D) of
the bushing and the frame (B). If there is a gap,
washers (1.2 mm thick) (MD #5113) will need to be
installed to minimize the gap on both sides of the
bushing.
13. Remove bolt (A).
14. Install washer (A) onto bolt (B) and apply anti-seize
compound to bolt shank only. Do NOT apply to threads.
15. Install bolt (B) with washers (C) as determined in Step
12, page 175.
16. Install three washers (D) and nut (E) onto bolt. Torque
to 332–346 Nm (245–255 lbf·ft).
17. Repeat steps 12, page 175
opposite side.
214077
MAINTENANCE AND SERVICING
to 16, page 175 for
B
A
C
Figure 4.155: Frame (Left Side Shown)
B
A
Figure 4.156: Frame Attachment
(Left Side Shown)
B
A
Figure 4.157: Frame Attachment (Left
Side Shown)
175
D
C
D
C
E
Revision A