P R E L I M I N A R Y
D
FR091521, R
IRECTION
8-3-12
Rotary Knob Replacement Procedure
NOTE:
The following instructions are applicable to replacement of Rotary Knobs on either on the Operator
Panel, or on the Touch Screen. The Knobs Kit contains Rotary Knobs for both.
8-3-12-1
Tools
None.
FRU Part #
Refer to
8-3-12-2
Time Required
5 min
8-3-12-3
Preparation
None
8-3-12-4
Rotary Knob Removal Procedure
1.) Grip the defective knob between your finger and thumb
2.) Lift straight up and remove from the control shaft - see
8-3-12-5
Rotary Knob Installation Procedure
1.) Carefully place a new Rotary Knob in position on the Operator Panel (or Touch Screen), taking care
to place the plastic alignment pin in the correct location.
2.) Gently push the Rotary Knob down until it snaps into position.
8-58
Section 8-3 - Control Console Components - Replacement Procedures
1
EVISION
Table 9-11
on page 9-10
Figure 8-67 Removing a Rotary Knob
.
V
S60N/V
S70N
IVID
IVID
Figure 8-67
below.
B
S
M
ASIC
ERVICE
ANUAL