Fan (Ac Distribution Box) Installation Procedure - GE VIVID S60N Basic Service Manual

P R E L I M I N A R Y
D FR091521, R
IRECTION
5.) Remove the other 3 remaining securing rubber holders.
8-5-22-5

Fan (AC Distribution Box) Installation Procedure

NOTE: When assembling a new AC Box Fan on the fan base, make use of the replacement rubber holders
(kit supplied with the new Fan).
1.) From the underside of the fan, thread the rubber holder through the aperture on the fan and pass
the rubber holder through the aperture on the fan base -
2.) Pull the rubber holder through from above the fan base until it fastens the fan securely to the base.
Repeat this task using the 3 remaining rubber holders provided.
3.) Connect the fan cable to the connector on the AC Distribution Box -
4.) Place the Fan in position then fasten with the 4 securing screws (previously removed) -
5.) Install the AC Distribution Box:
•
6.) Turn ON power to the system.
8-144 Section 8-5 - Electronic Cage Components - Replacement Procedures
1
EVISION
Figure 8-175 Flexible Rubber Holders - Cut and Remove
AC Distribution Box Removal Procedure on page 8 - 139
V S60N/V S70N
IVID IVID
Figure 8-175.
Figure
B S M
ASIC ERVICE ANUAL
8-174.
Figure 8-173.