P R E L I M I N A R Y
D
FR091521, R
IRECTION
8-3-11-5
Mechanical Trackball and Housing Installation Procedure
1.) Place a flat washer on each of the three retaining screws extending from the base board.
2.) Carefully place the new Mechanical Trackball Board and Housing in position on the keyboard
assembly (refer to
3.) Secure the Trackball Housing using the 3 new nuts supplied with the kit.
4.) Carefully re-connect the 2 cables (previously disconnected) -
5.) Re-fit the Keyboard Bottom Cover:
•
Alphanumeric Keyboard Installation Procedure on page 8 - 53
6.) Install the Keyboard Assembly: on the system.
•
Operator Panel Keyboard Assembly Installation Procedure on page 8 - 47
7.) Place the trackball into position in the Operator Panel.
8.) Return the trackball ring and turn to secure the trackball in its housing -
9.) Turn ON power to the system.
1
EVISION
Figure 8-66 Trackball Board and Housing Removed
Figure
8-65).
Chapter 8 - Replacement Procedures
V
S60N/V
S70N
B
IVID
IVID
Figure
8-65, left.
Figure
S
M
ASIC
ERVICE
ANUAL
8-63.
8-57