Connectivity Overview; Physical Connection; Stand-Alone Vivid™ S60/Vivid™ S70; Sneaker Net" Environment - GE VIVID S60N Basic Service Manual

P R E L I M I N A R Y
D FR091521, R
IRECTION
Section 3-7

Connectivity Overview

3-7-1

Physical Connection

There are several possible connection methods, as outlined below.
3-7-2 Stand-alone Vivid™ S60/Vivid™ S70
No network connection needed.
3-7-3

"Sneaker Net" Environment

No network connection needed.
Use removable media to move data from the Vivid™ S60/Vivid™ S70 to another unit.
3-7-4 Wired Ethernet from Vivid™ S60/Vivid™ S70 to a Workstation
Either of these situations may apply:
• Direct Cable Connection from Vivid™ S60/Vivid™ S70 to a workstation via a Crossover Cable.
You will only need a Crossover Cable for network (TCP/IP) use to connect the two units this way.
a.) Connect one end of the crossed network cable to the network connector on the Vivid™ S60/
b.) Connect the other end to the network connector to the Workstation.
• Connection via a Peer-to-Peer network.
You will need a network hub and one network cable for each unit connected to the hub.
• Connection via Hospital Network.
You will need one network cable to connect the Vivid™ S60/Vivid™ S70 to a wall jack on the
hospital's network.
3-7-5 Connection from Vivid™ S60/Vivid™ S70 to a DICOM Server on a Network
You will need one network cable.
1) Connect one end of the cable to the Ethernet connector on Vivid™ S60/Vivid™ S70.
2) Connect the other end of the cable to the wall jack.
NOTE: If a Peer-to-Peer network is connected to the hospital's network, you may connect the Vivid™ S60/
Vivid™ S70 to the Peer-to-Peer network.
3-40
1
EVISION
Vivid™ S70.
Section 3-6 - Configuration
V S60N/V S70N
IVID IVID
B S M
ASIC ERVICE ANUAL