Remove The 21.5 Inch Monitor - GE VIVID S60N Basic Service Manual

P R E L I M I N A R Y
D FR091521, R
IRECTION
8-3-1-4

Remove the 21.5 inch Monitor

1
2
1 - BIF-to-Display: HDMI
2 - Ground (from HDMI cable and to Arm)
3 - USB
2.) The cables are secured with P clamps and screws.
Disconnect the monitor cables from the monitor as described below:
a.) Disconnect the DVI cable, including P clamp and screw[1].
b.) Remove the serrated lock washer and screw to release the Ground cables [2].
c.) Disconnect the USB cable, including P clamp and screw [3].
d.) Disconnect the Power cable, including P clamp and screw [5].
e.) Remove the serrated lock washer and screw to release the Ground cable from the Power
f.) Remove screw and P clamp positioned in center of monitor [8] securing two cables plus ground
3.) Remove the two securing screws [7].
4.) Loosen the two captive screws [6].
5.) Hold the monitor with both hands and carefully move it to align the captive screws with the widest
part of the key-hole slots and remove the monitor.
Carefully place the monitor face-down on a clean, soft, stable surface.
NOTE: After removing the Front Cover, if not installing the replacement Monitor immediately, keep the cover
and screws in a safe place as they will be required later for refitting to the new Monitor.
8-32 Section 8-3 - Control Console Components - Replacement Procedures
1
EVISION
Figure 8-33 Monitor Cables
Cable [4].
wire from the arm.
V
IVID
(cont'd)
4 - Ground (from power cable)
5 - Power-to-Display
6 - Captive screws
7 - Securing screws
8 - Screw and P clamp
S60N/V S70N B
IVID ASIC
3
5
4
8
6
7
S M
ERVICE ANUAL