P R E L I M I N A R Y
D
FR091521, R
IRECTION
•
•
Possible reasons:
•
•
3-8-5-3
To Modify the Setup for a Server in the List
NOTE:
Both the pre-defined servers and new servers can be modified.
Follow this procedure to modify the setup for a server in the list:
1) Highlight the server you want to modify.
2) Select Modify.
3) Update the information as needed.
4) Select Check to verify that the server is found.
This check is a network Ping. A symbol to the right for the Check button indicates the result:
•
A green check mark next to the Check button indicates that the IP-Address is found on the network.
•
A red mark indicates that the IP address can't be found.
Possible reasons:
•
•
5) Select OK to confirm your new settings, or Cancel to leave without doing any changes.
3-8-5-4
To Delete a Server from the List
To Delete a server from the list:
1) Highlight the server you want to delete from the list.
NOTE:
You can only delete extra servers. The predefined servers (listed on-screen) can be modified, but not
deleted.
2) Select Remove.
3-8-6
Save the New Settings
1) Press Save Settings to save the new settings.
The new settings are saved to a common settings file. After a restart, the settings are also included in
other screens.
2) Restart Vivid™ S60/Vivid™ S70 to activate the changes.
3)
3-8-7
Wireless Network Configuration
The following procedure is used to configure the Vivid™ S60N and Vivid™ S70N for a wireless network
environment. This procedure is required for every new wireless network.
3-44
1
EVISION
A green check mark next to the Check button indicates that the IP-Address is found on the
network.
A red mark indicates that the IP address can't be found.
No network connection between the Vivid™ S60/Vivid™ S70 and the server.
The wrong IP Address.
No network connection between the Vivid™ S60/Vivid™ S70 and the server.
The wrong IP Address.
Section 3-6 - Configuration
V
S60N/V
S70N
IVID
IVID
B
S
M
ASIC
ERVICE
ANUAL