P R E L I M I N A R Y
D
FR091521, R
IRECTION
8-2-6
Blank Cover Replacement Procedure
Note:
The removal and installation procedure for the Blank Cover is the same as that described for
the DVD and Printer Cover Replacement Procedure section, on page 8-13 in this case making
use of the blank cover.
8-2-6-1
Tools
Phillips screwdriver.
FRU Part #
Refer to
8-2-6-2
Time Required
5 min
8-2-6-3
Preparations
Shut down the Vivid™ S60/Vivid™ S70 ultrasound unit, as described in
8-2-6-4
Blank Cover Removal Procedure
Note:
The Blank cover is secured to the mechanical platform by 4 snap-lock securing clips on the
inner side of the cover - illustrated below.
1) Remove the right side cover:
•
2.) Grip the bottom of the cover and pull it towards you to release it from the snap-lock securing clips
(Figure
Securing Clips
8-2-6-5
Blank Cover Installation Procedure
1) Return the cover to the right of the system, carefully aligning the 4 snap-lock securing clips with the
securing pins.
2.) Push the cover until it clicks in position.
3.) Install the right side cover.
•
8-14
1
EVISION
Table 9-8
.
on page 9-7
Right Side Cover Removal Procedure
8-30). Remove the cover.
Figure 8-8 Removing the Blank Cover
Right Side Cover Installation Procedure
Section 8-2 - Covers - Replacement Procedures
V
S60N/V
S70N
IVID
IVID
Power Shut Down on page 4 -
B
S
M
ASIC
ERVICE
ANUAL
7.