Cfe (Cfront End) Board Replacement Procedure; Tools; Time Required; Preparation - GE VIVID S60N Basic Service Manual

P R E L I M I N A R Y
D FR091521, R
IRECTION
8-5-11

CFE (cFront End) Board Replacement Procedure

CAUTION
NOTE: After physical replacement of the CFE Board, it is mandatory to first reinstall the Vivid™ S60 or Vivid™
S70 software application. Follow the instructions commencing in
8-5-11-1

Tools

Appropriate Phillips screwdriver.
FRU Part #
Refer to
8-5-11-2

Time Required

15 minutes
8-5-11-3

Preparation

Shut down the Vivid™ S60/Vivid™ S70 ultrasound unit, as described in
NOTE: When replacing the CFE Board, it is necessary to remove the four TRX32 Boards from the defective
CFE Board and install them in the replacement CFE Board. This is described in the procedure steps.
8-5-11-4

CFE Board Removal Procedure

1) Remove the following covers: left side, right side, DVD, front.
•
•
•
•
2) Open and remove the Front End door assembly and place it on a stable surface:
•
3.) Remove the FEPS:
•
4.) Disconnect the ECG-to-CFE board cable - see
8-112 Section 8-5 - Electronic Cage Components - Replacement Procedures
1
EVISION
When performing these procedures, take precautions to avoid damage of
electrostatic-sensitive components. Always have the ESD wrist strap
connected either to the DIB chassis or to the GND plug at the rear of the
scanner, and to your hand.
If a battery is present, first remove the battery as it contains stored energy.
Refer to Battery Removal Procedure on page 8 -
Table 9-15
on page 9-14
Air Inlet (Left Side) Cover Removal Procedure on page 8 - 7
Right Side Cover Removal Procedure on page 8 - 10
DVD Cover Removal Procedure on page 8 - 11
Front Cover Removal Procedure on page 8 - 16
Opening and Removing the Front End Door Assembly on page 8 - 83
Front End Power Supply Removal Procedure on page 8 - 109
.
Figure 8-130 on page
V S60N/V S70N
IVID IVID
145.
step 11 on page
Power Shut Down on page 4 -
8-107.
B S M
ASIC ERVICE ANUAL
8-180.
7.