Table of Contents
Advertisement
GE M
S
EDICAL
YSTEMS
D
FK091075, R
IRECTION
8-2-6-4
Top Cover Lower Section Installation Procedure (cont'd)
9) Plug in the AC cable to the AC Dis. Box, shown in
8-10, and secure the cable to the other cables with a tie-wrap.
10) Plug all peripheral cables into their original locations in the connector panels.
11) Return the connectors panels cover, as described in
Procedure" on page
12) Fasten the top cover with the two screws located in the brackets underneath the top cover, on either
side of the unit, as shown in
13) Return the rear cover, as described in
14) Return the side covers, as described in
8-2-7
Gas Spring Cover Replacement Procedure
8-2-7-1
Tools
Use the appropriate Phillips-type screw drivers, as indicated in the gas spring cover replacement
procedures.
8-2-7-2
Preparation
Shut down the Vivid 3N Pro/Expert ultrasound unit, as described in
8-2-7-3
Gas Spring Cover Removal Procedure
The procedure for removing the gas spring cover is identical to the procedure for removing the lower
section of the top cover, as described in
page
8-9.
8-2-7-4
Gas Spring Cover Installation Procedure
The procedure for installing the gas spring cover is identical to the procedure for installing the lower section
of the top cover, as described in
04
EVISION
8-8.
8-2-6-4 "Top Cover Lower Section Installation Procedure" on page
Chapter 8 Replacement Procedures
Figure 8-10 "AC Distribution Box Cables" on page
Figure 8-9 "Top Cover (Lower Section) Screws" on page
8-2-4-4 "Rear Cover Installation Procedure" on page
8-2-2-4 "Side Covers Installation Procedure" on page
8-2-6-3 "Top Cover Lower Section Removal Procedure" on
V
3N P
/E
IVID
RO
XPERT
8-2-5-4 "Connector Panels Cover Installation
Chapter 3 -
Installation.
S
M
ERVICE
ANUAL
8-9.
8-7.
8-4.
8-12.
8-13
Advertisement
Table of Contents
