Replacing The Battery; Troubleshooting; Types Of Notifications; Procedure For Warnings And Error Messages - Otto Bock 490E75 1 C Series Instructions For Use Manual

Maintenance and repair

8.2.3 Replacing the battery

Batteries may only be replaced by qualified personnel.

8.3 Troubleshooting

INFORMATION
In the event of communication problems in the bus system of the controls, the system triggers an emergency stop
and thus prevents any uncontrolled functions.
► Note that after every emergency stop, you have to turn the power wheelchair control unit on again.
► If the driving function is still not available after turning the control unit on again, activate pushing mode by
releasing the brake.
► Inform the qualified personnel immediately.
Faults are indicated on the control panel LCD screen, on the LCD monitor (if installed) or on the attendant control
(if installed). The following table shows the individual notifications as well as the associated fault sources and pos­
sible causes and measures.
If the measures described here do not resolve the faults completely, contact your specialist dealer. The specialist
dealer is able to read the exact error codes with a handheld programming device and can perform a targeted sys­
tem analysis.
The control unit stores a list of all faults that occur. The specialist dealer reads this information, for example during
a general overhaul of the power wheelchair. Based on the saved data, the specialist dealer determines future ser­
vice and maintenance intervals.
Faults are displayed on the LED display fields on the control panel. The following table shows the individual notific­
ations as well as the associated fault sources and possible causes and measures.
If the measures described here do not resolve the faults completely, contact your specialist dealer. The specialist
dealer is able to read the exact error codes with a handheld programming device and can perform a targeted sys­
tem analysis.
The control unit stores a list of all faults that occur. The specialist dealer reads this information, for example during
a general overhaul of the power wheelchair. Based on the saved data, the specialist dealer determines future ser­
vice and maintenance intervals.

8.3.1 Types of notifications

Warning
A warning indicates a status or malfunction of one or several components of the power wheelchair. The function of
components without errors is not restricted.
For example, if the connection between the control unit and seat motor is faulty, this error will only be indicated if
the user attempts to activate the motor. However, the driving function is still available.
Error
An error affects one or several functions of the power wheelchair. The power wheelchair and its functions are not
fully operational until the fault is resolved.
Structure of an error message
The control device display shows both errors in the control system itself as well as errors in electrical components
of the power wheelchair or errors in the cabling. The error message contains the following information:
• Affected module – e.g. JSM = joystick module (control panel); PM = power module (control device), Omni Dis­
play (display module), Omni IO (connection module)
• Error code (4 characters)
• Abbreviated error description

8.3.2 Procedure for warnings and error messages

• If a warning or error message appears, the power wheelchair can often no longer be driven. In this case, the
error message must be noted, the control unit switched off and the qualified personnel informed of the error
message immediately.
• If the error is related to a component which is not currently being used (e.g. to an actuator for adjusting the
seat function), the driving function of the power wheelchair is still theoretically usable. An error message simply
appears at regular intervals.
Nonetheless, the control unit must be switched off for several minutes in this case. If the error message contin­
•
ues to appear after switching on the control unit, the error message must be noted, the control unit switched
off again and the qualified personnel informed of the error message immediately.
106 490E75=1_C