Main Menu - Mitsubishi Electric MELDAS 600 Series Instruction Manual

'.
3.3 Main menu
The following menu appears on the VDS when the M6 Maintenance Tool is started in the normal mode.
5" (prompt) appears at the bottom of the screen, waiting for the command input. When a menu No.
from the VDS is input and [Enter] is pressed, the screen changes to the corresponding tool function.
**hm** M6 MAINTENANCE TOOL [BND-O23WOll -AO] *wnHr*r\*
1)
Memory Back Up
2) Serial Number and CNC type, Unit type Set
3) Setvo,Spindle F/w Down Load
4) Command Line Mode
> 1 [Enter]
\
/
\
Prompt Command input (for Memory Back Up)
M6 Maintenance Tool commands
I) Memory Back Up
This command is used to back up the FROM and SFtAM data of cassettes mounted on the on-
board FROM, SFtAM or C-BUS #l to the C-BUS #2 backup cassette.
2) Serial Number and CNC type, Unit type Set
This command is used to set the CNC serial No., CNC type, and unit type.
3) Servo, Spindle Down Load
This command is used to download the servo and spindle F/w to the amplifier.
4) Command tine Mode
This command is used to designate a command and address in the command line and backs it up
to the memory backup.
This command differs from the method for menu commands 1) to 3), in that the commands are
M500 offline monitor-type interactive format commands.
-5-